Then take the "config ist" and simply name it to "ist" which is the default file that Clover looks for when you select a MacOS drive. If it did, then great! What you can do is rename the original ist to something like "ist" or "ist", something memorable to remind you that it's the original file that was working properly. Did it fix the problem or cause the machine to boot faster? If not, then try editing the copy again. Now reboot your machine, but when in Clover go to Options -> Configs, and select the copy that you just finished editing, and continue booting. Open it by double-clicking the file and launch Clover Configurator for a graphical environment or right-click the file, select "Open with.", then select TextEdit to use the text editor to edit the file. Now you can either "config ist" to distinguish it from the primary. ![]() I prefer to keep filenames without spaces, but you should be able to leave yours as-is without problems. If you're using a standard Windows keyboard and haven't yet mapped the correct keys, use the Windows key between the Ctrl and Alt keys along with C to copy and V to paste. The steps to remap the keys explained earlier. Note: On an Apple keyboard the keys directly on the sides of the spacebar are Command keys, but on a Windows keyboard these are Alt keys. Basically as long as the entry starts with "config" then it should be visible when you select other configurations. If you do something similar you can still give descriptive names such as "config_ist", "config_1.plist", "ist" (previous example minus the underscore), and more. My solution was to rename the extra entries so that they started with "config" before the ".plist" extension, and that fixed it. I had to hook up the flash drive to another machine to confirm those extra entries were still there, which they were. But I noticed that when I would boot my machine and get into Clover, I would go to Options, go to Configurations", and the only entry in the list would be the "ist" file. I eagerly copied these to my EFI/CLOVER folder so that I would have an assortment to test out. Follow same steps as in Step 2 but choose Catalina SSD rather than the USB Drive.Ĭredits GUIDE - Create Catalina 10.When getting pre-built configurations for my AMD system, each configuration was named by the processor or board type, such as "ist" or "ist". Now you will need to do the Clover EFI steps again but this time to your new Catalina SSD.Remember to select boot from Catalina if its not already selected and when it boots up, Go to Disk Utilty and format your SSD to use APFS.ĭuring installation process the macOS will reboot several times.From the clover menu, enter option o and enter -lilubetaall on the Boot Args option and then Return.Boot from your new USB Drive (on USB2 port).Step Three: Install macOS Catalina from new bootable USB In here, you'll want to drop in the required Kexts as well as any other Kexts you need for your system. You should be in the directory /Volumes/EFI/CLOVER/kexts/Other/. Then, navigate to the "kexts" folder, then to "Other". Open up the EFI partition (location: /Volumes/EFI/), and navigate to "EFI", then to "CLOVER". Now on the Installation Type Tab Click on the Customize option.Ĭopying Files to EFI partition on Hackintosh macOS Catalina USB Installer. ![]() On the Destination Select tab, click on the option Change Install Location.run the clover_version_rev.pkg that you downloaded.Make sure you re-able SIP after you are done by running csrutil enable reversing the process above Hold down Command-R to reboot into Recovery Mode. FIX: Click the Apple symbol in the Menu bar.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |